Cisco Lab-3: step by step vlan configuration and assigne ports on vlans

Lab-3: step by step vlan configuration and assigne ports on vlans

Step 1:Creating Normal Range Vlan 100 and 200

SW1#conf t

Enter configuration commands, one per line. End with CNTL/Z.

SW1(config)#vlan 100

SW1(config-vlan)#name CSE-DEP

SW1(config-vlan)#exit

SW1(config)#vlan 200

SW1(config-vlan)#name EEE-DEP

SW1(config-vlan)#exit

Step 2 Assign Ports to The vlans 

       Assign Ports to vlan 100

SW1(config)#int range ethernet 0/0 - 1

SW1(config-if-range)#switchport mode access

SW1(config-if-range)#switchport access vlan 100

SW1(config-if-range)#exit

 

      Assign Ports to vlan 200

SW1(config)#interface range ethernet 0/2 - 3

SW1(config-if-range)#switchport mode access

SW1(config-if-range)#switchport access vlan 200

SW1(config-if-range)#exit

Step 3: Verification of Vlans 

SW1#show vlan brief

VLAN Name                             Status    Ports
---- -------------------------------- --------- -------------------------------
1    default                          active    Et1/0, Et1/1, Et1/2, Et1/3
                                                Et2/0, Et2/1, Et2/2, Et2/3
                                                Et3/0, Et3/1, Et3/2, Et3/3
100  CSE-DEP                          active    Et0/0, Et0/1
200  EEE-DEP                          active    Et0/2, Et0/3
1002 fddi-default                     act/unsup
1003 token-ring-default               act/unsup
1004 fddinet-default                  act/unsup
1005 trnet-default                    act/unsup